Armourgrout BP12

Armourgrout BP12

Installation Method Statement PDF

Armourgrout BP12

Material Data Sheet PDF

Armourgrout BP12

Safety Data Sheet PDF

1. GENERAL DESCRIPTION:

Armourgrout BP12 is a blend of 70 Pen bitumen and fine limestone conforming to the following DOT specification for road stud fixative.

2. PRODUCT:

Armourgrout BP12 is a standard grade cats eye adhesive for bonding road studs into concrete and asphalt surfacing. The material should receive constant mechanical agitation during the melting/ application process.

3. PHYSICAL PROPERTIES:
Specific Gravity1.85 ± 0.05
Product Pouring Temperature160 / 200°c
Maximum Safe Heating Temperature230°c
Penetration Value 23 ± 5 dmm
Softening Point85 ± 5°c
Flash Point – COC> 250°c
4. SPECIFICATION:

The binder shall conform to BS3690 Part 1 Grade 70 Pen and shall constitute 25 – 30% of the mixture.

The fine limestone shall be of suitable grade of which a minimum of 80% shall pass a 75um test sieve and shall constitute 70 – 75% of the mixture.

5. CHEMICAL RESISTANCE:

Bituminous products soften in contact with petroleum solvent and mineral oils. The product has good resistance to dilute acids and alkalis.

COMPOSITION: A blend of penetration grade bitumen and fine limestone.
STORAGE: Store in a cool dry place preferably under cover and away from direct sunlight.
PACKAGING: Multiply silicone lined sacks – 25kgs Net.

6. SAFE HANDLING PRECAUTIONS:

* Do not exceed the maximum safe heating temperature.
* Do not allow the hot material to come into contact with water as the product will react violently.
* Always wear the recommended protective clothing – see below.

7. FIRE & EXPLOSION HAZARDS:

FLAMMABILITY LIMITS
Upper
– Not applicable.
Lower – Not applicable.

EXTINGUISHING MEDIA
Small Fire – Foam / Water Fog.
Large Fire – Foam / Dry Powder / CO² / Sand / Earth.

SUPPLY CLASSIFICATION
Not dangerous for supply.

8. ACUTE HEALTH HAZARDS & ADVICE:

Bituminous products present no acute health hazard at ambient temperature. However, as these materials are normally handled at elevated temperatures when their physical state changes to a liquid, the bitumens present in these products give off fumes which are undesirable to inhale as very small quantities of HYDROGEN SULPHIDE may be present in the bitumen.

RECOMMENDED PROTECTIVE CLOTHING
Overalls, Goggles / Visor, Gloves and Closed Safety Boots AT ALL TIMES when handling hot products.
INHALATION
Inhalation of the vapours should be avoided.
INHALATION FIRST AID
Remove the affected person to fresh aid. If breathing has stopped administer artificial respiration. Give cardiac massage if necessary. If the person is breathing but unconscious place in the recovery position. Obtain medical assistance immediately.
SKIN CONTACT
Bituminous products present no acute health hazards to the skin other than burning when handling at elevated temperatures.
SKIN CONTACT FIRST AID
Flush the contaminated skin with cold water. DO NOT ATTEMPT TO REMOVE THE BITUMEN. Cover the burn with a sterile dressing. Do not apply any medication to the affected part. Obtain medical attention immediately.
EYE CONTACT
Contact with fumes may cause irritation and redness.
EYE CONTACT FIRST AID
Irrigate with copious amounts of water for 10 / 20 minutes and seek medical advice immediately.
PRECAUTIONS
Avoid contact with the skin by use of suitable protective clothing.
TRANSPORTATION
Not classified as dangerous for transportation.
FURTHER INFORMATION:
Additional information on the product is given in the system Safety Data Sheet and Installation Method Statement or by contacting Walker Sealants Ltd.

Latest Revision – December 2021