Armourjoint® BP02B

Armourjoint® BP02B

Installation Method Statement PDF

Armourjoint® BP02B

Material Data Sheet PDF

Armourjoint® BP02B

Safety Data Sheet PDF

1. GENERAL DESCRIPTION:

Armourjoint® BP02B is an elastomeric polymer modified bituminous bridgejoint binder, mixed with graded aggregate to form a flexible asphaltic plug joint in asphalt and concrete carriageways.

2. PRODUCT:

Armourjoint® BP02B can accommodate a movement range of ± 30mm in a standard APJ installation of 500mm width. In service the system is resistant to plastic flow and deformation at surface temperatures of 60°C providing a tough, resilient and flexible APJ suitable for locations where heavy trafficking is encountered.

3. PHYSICAL PROPERTIES:
Density @ 25°c1.15 ± 0.05
Flash Point (COC) °c250°c
Minimum Application Temperature+ 3°c
Product Pouring Temperature170 ± 10°c
Maximum Safe Heating Temperature195°c
Penetration Value @ 25°c60 ± 15 dmm
Flow Resistance @ 60°c / 5hrs≤ 1mm
Softening Point R&B°c95 ± 10°c
Extension Test @ 3.2mm / per hr / 2°c≥ 120%
Extension / Recovery @ -25°c5 cycles
Accomodation FactorVisco-elastic
Service Temperature Range-30°c / +70°c
4. CHEMICAL RESISTANCE:

Bituminous products soften in contact with petroleum solvent and mineral oils. The product has good resistance to dilute acids and alkalis.

STORAGE: Store in a cool dry place preferably under cover and away from direct sunlight.
COMPOSITION: A polymer modified bitumen containing graded extender with adhesion agents.
PACKAGING: Poly Lined Silicone sacks – 20kgs Net.

5. SAFE HANDLING PRECAUTIONS:

*Do not exceed the maximum safe heating temperature.
*Do not allow the hot material to come into contact with water as the product will react violently.
*Always wear the recommended protective clothing – see below.

6. ACUTE HEALTH HAZARDS & ADVICE:

Armourjoint® BP02B presents no acute health hazard at ambient temperature. However, as these materials are normally handled at elevated temperatures when their physical state changes to a liquid, the bitumens present in these products give of fumes which are undesirable to inhale as very small quantities of HYDROGEN SULPHIDE may be present in the bitumen.

RECOMMENDED PROTECTIVE CLOTHING:
High Visibility Jacket, Hard Safety Helmet, Overalls, Goggles / Visor, Armlet Gloves and Closed Safety Boots AT ALL TIMES when handling hot product.
INHALATION:
Inhalation of the vapours should be avoided.
INHALATION FIRST AID:
Remove the affected person to fresh aid. If breathing has stopped administer artificial respiration. Give cardiac massage if necessary. If the person is breathing but unconscious place in the recovery position. Obtain medical assistance immediately.
SKIN CONTACT:
Bituminous products present no acute health hazards to the skin other than burning when handling at elevated temperatures.
SKIN CONTACT FIRST AID:
Flush the contaminated skin with cold water. DO NOT ATTEMPT TO REMOVE THE BITUMEN. Cover the burn with a sterile dressing. Do not apply any medication to the affected part. Obtain medical attention immediately.
EYE CONTACT:
Contact with fumes may cause irritation and redness.
EYE CONTACT FIRST AID:
Irrigate with copious amounts of water for 10/20 minutes and seek medical advice immediately.
PRECAUTIONS:
Avoid contact with the skin by use of suitable protective clothing.
TRANSPORTATION:
Not classified as dangerous for transportation.
FURTHER INFORMATION:
Additional information on the product is given in the system Safety Data Sheet and Installation Method Statement or by contacting Walker Sealants Ltd.

Latest Revision – December 2021